Issue link: https://beckershealthcare.uberflip.com/i/1545216
The measuring scale on the spreader handle helps to gauge the gap. Use in Hip Surgery Use in Knee Surgery Berger Block Positioner Designed by Richard Berger, MD Designed for lower extremity positioning with dual height options #2750-00 Hyperflex Foot Positioner Assembly Designed by Morteza Meftah, MD and Ira Kirschenbaum, MD Designed to help secure the foot for positioning of the knee in the hyperflex position #2589-00 Useful in arthroscopic knee surgery to hold the leg in position Designed by Gregory Fanelli, MD Leg Stabilizer #8840 DRAPE Connelly Leg Positioning Board #2626-01 Optional Leg Stabilizer (Not included in Set) #8840 Connelly Leg Positioner Footpiece #2626-FP Connelly Leg Positioning Set A clamp free leg positioner board for partial or total knee replacement designed to go UNDER the drapes, the sterilizable footpiece is used for easy positioning Designed by Camille Connelly, MD The board can be stabilized on the OR table with Velcro or tape Set includes the footpiece Two (2) Sterile Pads/Wraps are included with each new purchase Set #2626-00 Also Available Individually Designed by John Cherf, MD Supports the lower extremity for prepping before hip or knee surgery Cherf Leg Holder Designed to help lift and position the thigh from above during knee surgery Chandran Thigh Lift Positioner Designed by Rama E. Chandran, MD The optional thigh lift adapter is designed for use with a hydraulic lift device instead of the manual lift rod with table clamp. Optional Adapter #4167-03 Optional Rotating Table Clamp #9125 Positioner Set #4167-00 Also Available Individually #1866-D M A D E E X C L U S I V E LY FOR INNOMED IN G E R M A N Y Femoral Tibial Spreader with 90° Long Arms, Round Pads and Measuring Scale Longer 90° arms are helpful with visualization and useful for large patients Designed by Adam Almaguer, MD Devices with a measuring function are considered non-critical, non-calibrated, and are intended for reference- only measurements. While it provides a helpful visual guide for relative measurements, it is not calibrated to specific precision standards. Measurements taken with this device should not be considered accurate enough for critical applications requiring strict dimensional tolerances. General manufacturing tolerances of +\- 1% at each graduation, or 2% of the full scale apply, but no conformance qualifications are provided or implied. Accuracy Statement for devices with a measuring function: #2270 FREE TRIAL ON MOST INSTRUMENTS 1.800.548.2362 103 Estus Drive, Savannah, GA 31404 info@innomed.net 912.236.0000 Phone 912.236.7766 Fax Innomed-Europe Tel. +41 41 740 67 74 info@innomed-europe.com © 2026 Innomed, Inc. ISO 13485:2016 www.innomed.net